Lexus NX: Front Speed Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ AVS - - *1 FRONT SKID CONTROL SENSOR WIRE LH *2 FRONT SPEED SENSOR LH N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT TIRE Click here 2. REMOVE FRON
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT SKID CONTROL SENSOR WIRE L
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 1 MOULDING TAPE (a) Clean the No. 1 moulding tape installation surface with a non-residue solvent. (b) Apply primer to the No. 1 mo
System Description
SYSTEM DESCRIPTION FUNCTION OF MAIN COMPONENTS Component Function Multiplex tilt and telescopic ECU This ECU sends a control signal to the tilt motor and telescopic motor, based on signals from each switch, to adjust the steering position. Tilt motor (Built-in tilt position sensor)
© 2016-2024 Copyright www.lexunx.com
