Lexus NX: Customize Parameters

Lexus NX Service Manual / General / Setup / Customize Parameters

READ NEXT:

 Procedure

PROCEDURE PROCEDURE 1. CUSTOMIZE DYNAMIC RADAR CRUISE CONTROL SYSTEM Click here 2. CUSTOMIZE LANE TRACING ASSIST SYSTEM Click here 3. CUSTOMIZE ROAD SIGN ASSIST SYSTEM Click here 4. CUSTOMIZE AD

 When Disconnecting Or Reconnecting Battery Terminal

Automatic Learning ChartAUTOMATIC LEARNING CHART AUTOMATIC LEARNING PERFORMED WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL When the cable is disconnected/reconnected to the auxiliary ba

 When Replacing Or Removing/installing Parts

SEE MORE:

 Automatic High Beam Main Switch

InspectionINSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (AUTOMATIC HIGH BEAM MAIN SWITCH) (a) Remove the combination switch assembly. Click here (b) Inspect the automatic high beam main switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resi

 Dtc Check / Clear

DTC CHECK / CLEAR DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. Click here Body Electrical > Air Conditioner &

© 2016-2026 Copyright www.lexunx.com