Lexus NX: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Data List.
(e) According to the display on the Techstream, read the "Data List".
Body Electrical > Telematics > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | Total distance traveled | Min.: 0, Max.: 16777215 | - | - |
| Total Distance Traveled - Unit | Total distance traveled unit | -, km or mile | - | - |
| IMEI | IMEI of DCM (telematics transceiver) | 15 digits | - | - |
| Software Version High | Software version of DCM (telematics transceiver) (10 digits from left) | 10 digits | - | - |
| Software Version Low | Software version of DCM (telematics transceiver) (10 digits from right) | 10 digits | - | - |
| MSISDN | MSISDN of DCM (telematics transceiver) | 16 digits | - | - |
| PLMN(MCC) | MCC of DCM (telematics transceiver) | 3 digits | - | - |
| PLMN(MNC) | MNC of DCM (telematics transceiver) | 3 digits | - | - |
| ICCID(High) | ICCID of DCM (telematics transceiver) (10 digits from left) | 10 digits | - | - |
| ICCID(Low) | ICCID of DCM (telematics transceiver) (10 digits from right) | 10 digits | - | - |
| Communication Status with TSC | Communication status with Service Center | Incomplete or Complete | Complete | - |
| Telematics Activation Status | DCM (telematics transceiver) activation status | Shipping or Active | Shipping: Not activated Active: Activated | - |
| Remote Vehicle Tracking | Display "Remote Vehicle Tracking" function enabled/disabled status | Not Avail or Available | NOT Avail: Following function disabled Available: Following function enabled | - |
| Brand TOYOTA | Bland name | No or Yes | No: Except TOYOTA Brand YES: TOYOTA Brand | - |
| OTA Reprogramming | Display "OTA Reprogramming" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| HELPNET Function | Display "Helpnet" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Stolen Vehicle Tracking | Display "Stolen Vehicle Tracking" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Automatic Collision Notification Function | Display "Automatics Collision Notification" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Manual Emergency Call Function | Display "Manual Emergency Call" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Wireless Health Check Function | Display "Wireless Health Check" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Stolen Vehicle Tracking Function | Display "Stolen Vehicle Tracking" function enabled/disabled status | Not Avail or Available | Not Avail: Following function disabled Available: Following function enabled | - |
| Telematics Microphone Volume Adjust | Setting of Telematics Microphone Volume Adjust | Min.: 1, Max.:11 | Displays customize setting of Telematics Microphone Volume Adjust | - |
| Telematics Speaker Volume Adjust | Setting of Telematics Speaker Volume Adjust | Min.: 1, Max.:14 | Displays customize setting of Telematics Speaker Volume Adjust | - |
| Green Indicator | The green indicator light on the emergency call switch panel illumination status | Lighting OFF, Nighttime Brightness-Low, Nighttime Brightness-Middle, Nighttime Brightness-High or Daytime Brightness | - | - |
| Red Indicator | The red indicator light on the emergency call switch panel illumination status | Lighting OFF, Nighttime Brightness-Low, Nighttime Brightness-Middle, Nighttime Brightness-High or Daytime Brightness | - | - |
| Beep | Beep volume | Min.: 1, Max.:14 | - | - |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Safety Connect System DTC No. Detection Item Link B153711 Telephone Sub Antenna Circuit Short to Ground B153713 Telephone Sub Antenna Circuit Open
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (a) Conn
Telephone Sub Antenna Circuit Short to Ground (B153711,B153713)
DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone antenna (navigation antenna assembly) DTC No. Detection Item DTC Detection Condition Trouble Area B153711 Te
SEE MORE:
Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) (U0155)
DESCRIPTION The ECM and combination meter assembly send and receiver signals via CAN communication. If a communication error occurs between the ECM and combination meter assembly, the ECM illuminates the MIL and stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area
Transmitter Battery
ReplacementREPLACEMENT PROCEDURE 1. REMOVE TRANSMITTER BATTERY (a) Push the release hook knob and extract the mechanical key. (b) Using a screwdriver with its tip wrapped in protective tape, remove the transmitter housing cover as shown in the illustration. HINT: Tape the screwdri
