Lexus NX: Safety Connect System
Lexus NX Service Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Dcm Operation History
- Dcm Activation
- Acn Call End
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Telephone Sub Antenna Circuit Short to Ground (B153711,B153713)
- DCM System Internal Failure (B15A804)
- Telephone Main Antenna Circuit Short to Ground (B15CB11,B15CB13)
- Green Indicator Remains Off
- Unable To Connect To Call Center
- Emergency Call Switch Illumination Circuit
READ NEXT:
Precaution
PRECAUTION WHEN DISCONNECTING AUXILIARY BATTERY CABLE NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery
Parts Location
PARTS LOCATION ILLUSTRATION *A w/o Navigation System *B w/ Navigation System *1 FRONT NO. 1 SPEAKER ASSEMBLY RH *2 FRONT NO. 2 SPEAKER ASSEMBLY RH *3 TELEPHONE MICROPHONE ASS
System Diagram
SYSTEM DIAGRAM
SEE MORE:
IG Power Source Circuit
DESCRIPTION When the power switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also receives power switch signals via this circuit. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect
Absorber Control Actuator (for Rear Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for LH Side Tester Connection Condition Specified Condition 1 (+) - 3 (-) 15 to 25°C 2.8 to 4.4
© 2016-2026 Copyright www.lexunx.com
