Lexus NX: Rear Shock Absorber
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o AVS - - *1 REAR NO. 1 SHOCK ABSORBER BRACKET LH *2 REAR SHOCK ABSORBER ASSEMBLY LH *3 REAR SUSPENSION ARM COVER LH - N*m (kgf*c
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. DISCONNECT R
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SHOCK ABSORBER ASSEMBLY LH (a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation. If ther
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the Techstream on. (c) Put the engine in inspection mode (maintenance mode). Click here (d) Start the engine. (e) Warm up the engine. (f) Enter the following menus
Initialization
INITIALIZATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform zero point calibration and sensitivity check if any of the following conditions occur:
The occupant detection ECU is replaced.
Accessories (seatback tray and seat cover,
© 2016-2026 Copyright www.lexunx.com
