Lexus NX: Lighting System
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- IG Signal Circuit
- ACC Signal Circuit
- Door Courtesy Switch Circuit
- Back Door Courtesy Switch Circuit
- Interior Light Circuit
- Interior Light Auto Cut Circuit
- Interior Light Switch Signal Circuit
- Footwell Light Circuit
- Power Switch Illumination Circuit
- Door Unlock Detection Switch Circuit
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 MAP LIGHT ASSEMBLY *2 SPOT LIGHT ASSEMBLY *3 VISOR ASSEMBLY RH *4 VISOR ASSEMBLY LH *5 VANITY LIGHT ASSEMBLY RH *6 VANITY LIGHT ASSEMBLY LH
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION ILLUMINATION CONTROL SYSTEM (Illuminated Entry System) HINT: When inspecting the following functions, make sure that the map light switch and spot light switch are in the DOOR posit
SEE MORE:
Hybrid Battery Pack Current Sensor Circuit Range / Performance (P0AC0-817)
DESCRIPTION A battery current sensor is installed to the positive (+) cable side of the HV battery and detects current flowing from the HV battery. The battery current sensor outputs voltage, which changes between 0 and 5 V according to the detected amperage, to the IB terminal of the battery voltag
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (for Manual Seat) Click here 2. REMOVE REAR SEAT ASSEMBLY (for Power Seat) Click here 3. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (a) for Manual Seat: (1) w/o Seat Heater System:
Using a clip remover, detach the 2 wire harness clamp
© 2016-2026 Copyright www.lexunx.com
