Lexus NX: P314 (hybrid Transmission / Transaxle)
Lexus NX Service Manual / Drivetrain / P314 (hybrid Transmission / Transaxle)
- Combination Switch
- Hybrid Transaxle Fluid
- Hybrid Transaxle Oil Seal
- Hybrid Transaxle System
- Hybrid Vehicle Transaxle
- Input Shaft Oil Seal
- Motor Water Jacket Cover Assembly
- Oil Cooler
- Shift Lever
- Shift Lever Position Sensor
- Shift Paddle Switch
- Transmission Control Cable
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for 8 Inch *B for 10.3 Inch *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT PANEL FINISH PLATE *3 INSTRUMENT SIDE PANEL LH *4
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL FINISH PLATE 2. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET Click here 3. REMOVE CONSOLE ARMREST ASSEMBLY Click here 4. REMOVE UPPER REAR CONSOLE PANE
SEE MORE:
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Clearance Warning ECU Assembly Destination information signal CAN Communication Line Hybrid Vehicle Control ECU Clearance Warning ECU Assembly Shift position signal
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY (a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) Connect the 2 connectors. 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Click here 3. INSTALL BACK DOOR
© 2016-2025 Copyright www.lexunx.com
