Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | for 8 Inch | *B | for 10.3 Inch |
| *1 | CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY | *2 | INSTRUMENT PANEL FINISH PLATE |
| *3 | INSTRUMENT SIDE PANEL LH | *4 | INSTRUMENT SIDE PANEL RH |
| *5 | LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL | *6 | MULTI-DISPLAY ASSEMBLY WITH BRACKET |
| *7 | NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY | *8 | NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
| *9 | NO. 1 SWITCH HOLE BASE | *10 | NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY |
| *11 | UPPER NO. 1 CONSOLE PANEL GARNISH | *12 | UPPER NO. 2 CONSOLE PANEL GARNISH |
ILLUSTRATION
| *1 | CONSOLE ARMREST ASSEMBLY | *2 | INTEGRATION CONTROL AND PANEL ASSEMBLY |
| *3 | SHIFT LEVER KNOB SUB-ASSEMBLY | *4 | SHIFT POSITION INDICATOR |
| *5 | UPPER REAR CONSOLE PANEL | *6 | UPPER REAR CONSOLE PANEL SUB-ASSEMBLY |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL FINISH PLATE 2. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET Click here 3. REMOVE CONSOLE ARMREST ASSEMBLY Click here 4. REMOVE UPPER REAR CONSOLE PANE
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch C
Installation
INSTALLATION PROCEDURE 1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Install the integration control and panel assembly to the rear upper console panel sub-assembly with the 2 screws. HINT:
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
w
Inspection
INSPECTION PROCEDURE 1. INSPECT HV BATTERY JUNCTION BLOCK ASSEMBLY (a) Inspect SMRB: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition x2-1 (+) - t5-1 (CBI) Auxiliary battery voltage not appl
© 2016-2025 Copyright www.lexunx.com
