Lexus NX: Front Camera System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range (C10001C,C10051C,C100A62,C1A9346,C1A9445,C1A9447,C1A9487-C1A961C)
- Buzzer Circuit Short to Battery (C1A4A12)
- Buzzer Circuit Short to Ground or Open (C1A4A14)
- Steering Vibrator System Missing Message (C1A7587)
- Front Recognition Camera Optical Axis Misalignment Malfunction (C1AA800)
- Front Recognition Camera Heater Malfunction (C1AAE00)
- Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U014087,U029387)
- Internal Control Module Software Incompatibility Not Programmed (U030051,U030057)
- Software Incompatibility with Body Control Module Not Programmed (U032251)
- Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)
READ NEXT:
Precaution
PRECAUTION PRECAUTIONS FOR FRONT CAMERA SYSTEM (a) Characteristics of forward recognition camera (1) The forward recognition camera has characteristics similar to human eyes. In conditions where the f
Parts Location
PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY *3 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY - SKID CONTROL ECU - -
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component (U030557)
DESCRIPTION The millimeter wave radar sensor assembly receives vehicle information from the forward recognition camera via CAN communication. If the vehicle information stored in the forward recognition camera differs from that stored in the millimeter wave radar sensor assembly, the millimeter wave
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. DISCONNECT FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP LH *a Claw Engagement (a) Using needle-nose pliers, detach the
© 2016-2025 Copyright www.lexunx.com
